Createbank(1)

Blitz3D Forums/Blitz3D Bug Reports/Createbank(1)

Abrexxes
 #1
*** trash ***

big10p
 #2
I see no bug. You're creating a 1-byte bank and then attempting to place a value in that bank with an offset of 1 - an offset of 0 references the first byte in a bank. 'Out of range' is only checked for in debug mode for speed reasons.

Abrexxes
 #3
omg ok, createbank (1) makes only 1 byte and not byte0+byte1

ok, trash this. ^^