GCSetMode 3 ?

OK.. so this has probably been answered before but I cant seem to find it.

I was just looking into GNet and I got the source for the gnetdemo.

It all seemed simple enough but then when I looked at the code again I noticed this

GcSetMode 3

I knew of manual and automatic.. but what does this third one do ?

Anyone know ?

It does not do anything. GCSetMode 3 = Mode 1 + 2 (automatic + manual)

The only further mode is 4 which will output debug data to console.

Ahh OK...

So calling that will nothing. I do wish the demo's didnt do that sort of thing... or at least had comments to explain the purpose/reason for the code being there.

Anyway... Thanx for the reply.

GCSetMode 5 = SELFDESTRUCTION? ;)

In fact GCSetMode 5 might be just the thing for you.
It's automatic but also gives out the debug messages...

GCSetMode 5
Graphics 640,480
image:TImage=LoadImage("max.png")
While Not KeyHit(key_escape)
  Cls
  DrawImage image,0,0
  DrawText GCMemAlloced(),0,0
  Flip
Wend

The only selfdestruction flag is GCMode 7. Although it should combine all, it directly killed BM 1.18 (haven't tried with BM 1.20 so far)