How to use Truespace convertor?

Hi all,

How to use Truespace convertor? Although it has only 3 buttons, I could not get .b3d from .cob.

(Specs and utils>Blitz3D Exporters>Truespace convertor)

Thanks in advance.
Sammy
:)

I have a newer version of TSConvert on my other laptop (file creation date 22/10/2002) that uses a standard windows selector dialog.

I couldn't get the version that downloads from Specs and utils (creation date 5/6/2002) to work with the cube.cob supplied either... But it seems to load and convert the plan and tricycle (can't test the test.b3d file it creates.)

Just browse to your cob file, then click on Done. Look in the TSConvert folder for a file called test.b3d

... better still, track down the newer version !

@BlackJumper,

Ok, where to get the newer version from?

Buy Ultimate Unwrap3D.

@Amanda:

You could try emailing Lee (TeraBit) using the link in the Specs&Utils page. If you get no luck there I could probably mail you a copy of the one I have on my system.

I just tried a bit of googling for this and had no luck.

You might want to check out this thread - not sure how helpful it will be, but does point to others working on converters.