I just turned my PC on and it seems to have lost my monitor settings - the PC thought it was a default plug and play monitor. Consequently the screen display was warped and stretched.
I altered the display on the monitor itself to get a square screen again, and downloaded the drivers and installed them, but it seems to be stuck at 60hz - there is a slight flicker to the screen. I've tried all screen resolutions (which change OK) and all refresh rates (which apparently change OK) but I can't get any difference to this apparent flicker - it almost as if every refresh rate is working at 60hz.
Anyone have any ideas how this could happen? It was working fine before I went out, when I turned it back on it's seemingly messed up.
I altered the display on the monitor itself to get a square screen again, and downloaded the drivers and installed them, but it seems to be stuck at 60hz - there is a slight flicker to the screen. I've tried all screen resolutions (which change OK) and all refresh rates (which apparently change OK) but I can't get any difference to this apparent flicker - it almost as if every refresh rate is working at 60hz.
Anyone have any ideas how this could happen? It was working fine before I went out, when I turned it back on it's seemingly messed up.