Wireframe question

in my editor I have 4 cams (Top, Left, Front and perspective) the thing im asking is this:
When I create a floor it places all the polys down so I can see it but as its only a poly mesh its to thin to show on the other cams. Is there a way to get a single poly to show when looking at it from the thin side in wireframe?

I have the same problem in KODE (my editor), and i use some kind of gizmo to show (at least) the position of the floor (plane).

I also thought that wireframe would show everything thats 'wireframe' but it doesnt.

if you set the entityfx to 16 (remove backface culling) it works :D