Centering a window

How would i go about this without having it end up 'between' two monitors on a dual monitor set up? (ie: i want to center it on the main monitor).

Purebasic has the #PB_Window_ScreenCentered flag for this and that works great, but in B+, all i can get it to do is end up half way between the two monitors in my dual monitor setup :)

Tracer

Hard code it. If the resolution width is twice the expected amount considering the vertical resolution, then divide the width by 4 instead of 2.

The problem is Wolron, these days i could place the second monitor 'below' my main monitor, or even above and to the right, etc .. so that kind of hardcoding doesn't really work.

for example:


Tracer

I know, it was a simple solution...

If you want to center it on one moniter then:

width=1024     'Your SINGLE MONITER's resolution dimensions here
height=768

winw=640
winh=480
winx=(width/2)-(winw/2)
winy=(height/2)-(winh/2)

window=CreateWindow("Centered Window",winx,winy,winw,winh)

Also I think there is a center window sample in the samples directory.

and use SetGadgetShape if any changes occur in Resolution,
and GagdetWidth(Desktop()) (as weel as Height) to get the width and height in unknown cases......of course